Kullanım Kılavuzu
Neden sadece 3 sonuç görüntüleyebiliyorum?
Sadece üye olan kurumların ağından bağlandığınız da tüm sonuçları görüntüleyebilirsiniz. Üye olmayan kurumlar için kurum yetkililerinin başvurması durumunda 1 aylık ücretsiz deneme sürümü açmaktayız.
Benim olmayan çok sonuç geliyor?
Birçok kaynakça da atıflar "Soyad, İ" olarak gösterildiği için özellikle Soyad ve isminin baş harfi aynı olan akademisyenlerin atıfları zaman zaman karışabilmektedir. Bu sorun tüm dünyadaki atıf dizinlerinin sıkça karşılaştığı bir sorundur.
Sadece ilgili makaleme yapılan atıfları nasıl görebilirim?
Makalenizin ismini arattıktan sonra detaylar kısmına bastığınız anda seçtiğiniz makaleye yapılan atıfları görebilirsiniz.
  Atıf Sayısı 1
 Görüntüleme 20
NUMERICAL INVESTIGATIONS AND BENCHMARKING OF THE PHYSICAL AND ELASTIC PROPERTIES OF 316L CUBIC LATTICE STRUCTURES FABRICATED BY SELECTIVE LASER MELTING
2022
Dergi:  
International Journal of 3D Printing Technologies and Digital Industry
Yazar:  
Özet:

The aim of this study is to investigate and benchmark the physical and elastic properties of strut-based lattice structures produced by selective laser melting from 316L stainless steel material, which has many uses in various sectors. Within the scope of the presented study, the relative density and relative elastic modulus for 27 types of strut-based lattice structures of different sizes with simple cubic (SC), body-centered cubic (BCC) and face-centered cubic (FCC) geometry were evaluated and compared. Numerical analyzes were utilized due to the evaluated design and dimensional configuration diversity, and consistent results were obtained with the studies published in the previous literature. The findings of the study showed that for all lattice structure types, volume fraction increases with the increasing diameter and decreases with the increasing cell size. With the utilization of same strut diameter and cell size FCC type lattice structures exhibit the highest volumetric fill while SC type lattice structures exhibit the lowest. The increase in the volume fraction increases the relative elastic modulus. For the same volume fraction, SC lattices represent the highest relative elastic modulus while FCC lattices indicate the lowest.

Anahtar Kelimeler:

0
2022
Yazar:  
Atıf Yapanlar
Dikkat!
Yayınların atıflarını görmek için Sobiad'a Üye Bir Üniversite Ağından erişim sağlamalısınız. Kurumuzun Sobiad'a üye olması için Kütüphane ve Dokümantasyon Daire Başkanlığı ile iletişim kurabilirsiniz.
Kampüs Dışı Erişim
Eğer Sobiad Abonesi bir kuruma bağlıysanız kurum dışı erişim için Giriş Yap Panelini kullanabilirsiniz. Kurumsal E-Mail adresiniz ile kolayca üye olup giriş yapabilirsiniz.
Benzer Makaleler






International Journal of 3D Printing Technologies and Digital Industry

Dergi Türü :   Uluslararası

Metrikler
Makale : 256
Atıf : 272
International Journal of 3D Printing Technologies and Digital Industry