Bu çalışmada, Al-7Si%10B4C metal matrisli kompozit malzeme, Al-%7Si toz karışımı içerisine ağırlıkça %10 oranında B4C ilave edilerek toz metalurjisi yöntemi kullanılarak üretilmiştir. Hazırlanan toz karışımları, 450 MPa basınç altında soğuk presleme işlemine tabi tutulmuş ve argon gazı atmosferinde farklı sinterleme sıcaklıklarında (550 oC, 570 oC ve 590 oC) 60 dakika süre ile sinterlenmiştir. Farklı sinterleme sıcaklıklarında üretilen Al7Si%10B4C kompozit malzemelerin mikro yapıları, SEM+EDS, X-ışını kırınımı (XRD) ve sertlik ölçümü ile karakterize edilmiştir. Çalışma sonucunda, sinterleme sıcaklığının artması ile matris fazında Al3,21Si0,47 ve matris-takviye arasında ise AlB12, AlB10, faz ve bileşikleri oluştuğu görülmüştür. Ayrıca sıcaklık değerlerindeki artışa bağlı olarak sertlik değerlerinde görülür bir artış olduğu belirlenmiştir.
In this study, the Al-7Si 10%B4C metal matrix composite material was produced using the powder metallurgy method by adding 10% B4C to the Al-7%Si powder mixture. The prepared powder mixtures were undergoing a cold pressure process at a pressure of 450 MPa and synthesized for 60 minutes at different synthesizing temperatures (550 oC, 570 oC and 590 oC) in the argon gas atmosphere. The micro-structure of the Al7Si%10B4C composite materials produced at different synthesis temperatures is characterized by SEM+EDS, X-ray breakdown (XRD) and hardness measurement. The study found that the increase in the synthesis temperature and the formation of phases and compounds between the matrix phase Al3,21Si0,47 and the matrix-supplement AlB12, AlB10. There is also a noticeable increase in hardness values due to the increase in temperature values.
In this study, Al-7Si%10B4C metal matrix composite material was produced by adding 10 wt. % B4C in weight into the Al-%7Si powder mixture, using powder metallurgy method. The prepared powder mixtures were subjected to cold press under a pressure of 450 MPa and sintered for 60 minutes at different sintering temperatures (550°C, 570°C and 590°C) in an argon gas atmosphere. Microstructures of Al7Si%10B4C composite materials produced at different sintering temperatures were characterized by SEM+EDS, X-ray diffraction (XRD) and hardness measurements. As a result of the study, it was observed that Al3,21Si0,47 in matrix phase and AlB12, AlB10, phase and compounds between matrix and reinforcement were formed by increasing the sintering temperature. Furthermore, it was determined that there is a significant increase in hardness values due to the increase in temperature values.
Alan : Fen Bilimleri ve Matematik; Mühendislik; Sağlık Bilimleri
Dergi Türü : Ulusal
Benzer Makaleler | Yazar | # |
---|
Makale | Yazar | # |
---|