Görüntüleme
5
İndirme
1
Bu çalışmada günlük hayatta en sık kullanılan vücut bölümlerinin başında gelen üst uzuvlara ait omuz ve dirsek eklemlerindeki kuvvet ve tork değerlerinin belirlenmesi amaçlanmıştır. Denekten dik konumda iken masada duran belirli bir yükü alması kendisine yaklaştırması ve geri bırakması istenmiştir. Deneğin bu görevi yerine getirirken gerçekleştirdiği hareketler esnasında omuz ve dirseğinde meydana gelen eklem kuvvet ve torklarının belirlenebilmesi için Newton-Euler metodu kullanılarak dinamik bir model oluşturulmuştur. Eklemlere ait konum verilerinin ölçülmesinde giyilebilir hareket sensörleri kullanılmıştır. Bu sensörlerden alınan hareket verileri ile oluşturulan dinamik model kullanılarak eklemlerdeki tork ve bağ kuvveti değerleri hesaplanmıştır. Elde edilen hesaplama sonuçları karşılaştırmalı olarak değerlendirilerek eklem kuvvet ve torklarının hangi durumlarda arttığı ve ne gibi tedbirlerle azaltılabileceği ortaya konulmuştur.
This study is aimed at determining the strength and turning values in the shoulder and rectal joints of the upper edges of the most commonly used parts of the body in daily life. He was asked to take a certain burden on the table while he was in a straight position and to get him back. A dynamic model was created using the Newton-Euler method to determine the joint strength and turns occurring in the shoulder and back during the movements it performed. In measuring the location data of the joints, wearable movement sensors have been used. Using the dynamic model created with the movement data obtained from these sensors, the turn and connection strength values in the joints are calculated. The results of the obtained calculation are compared and it is revealed in which cases the joint strength and turns are increased and with what measures can be reduced.
In this study, it was aimed to determine the forces and torques acting on the shoulder and elbow joints of the upper limbs, which are the most commonly used body parts in daily life. The subject was asked to take a certain load on the table while standing upright, bring him closer to himself and leave it back. A dynamic model was created using the Newton-Euler method to determine the joint force and torque occurring in the shoulder and elbow during the movements performed by the selected subject while performing this task. Wearable motion sensors were used to measure the location data of the joints. The torque and link force values in the joints were calculated using the dynamic model created with the motion data received from these sensors. The calculation results obtained were evaluated comparatively and it was revealed in which cases the forces and torques acting on the joints increased and what measures could be reduced.
Dergi Türü : Uluslararası
Makale Detay 
Benzer Makaleler
PDF Görüntüle
Dergi Bilgisi
Eseri Dinleyin
Alıntı Yap
Bu Sayfayı Yazdırın
Paylaş
Mendeley
