Kullanım Kılavuzu
Neden sadece 3 sonuç görüntüleyebiliyorum?
Sadece üye olan kurumların ağından bağlandığınız da tüm sonuçları görüntüleyebilirsiniz. Üye olmayan kurumlar için kurum yetkililerinin başvurması durumunda 1 aylık ücretsiz deneme sürümü açmaktayız.
Benim olmayan çok sonuç geliyor?
Birçok kaynakça da atıflar "Soyad, İ" olarak gösterildiği için özellikle Soyad ve isminin baş harfi aynı olan akademisyenlerin atıfları zaman zaman karışabilmektedir. Bu sorun tüm dünyadaki atıf dizinlerinin sıkça karşılaştığı bir sorundur.
Sadece ilgili makaleme yapılan atıfları nasıl görebilirim?
Makalenizin ismini arattıktan sonra detaylar kısmına bastığınız anda seçtiğiniz makaleye yapılan atıfları görebilirsiniz.
 Görüntüleme 15
Revealing patterns in the stressed-strained state of load-bearing structures in special rolling stock to further improve them
2023
Dergi:  
Eastern-European Journal of Enterprise Technologies
Yazar:  
Özet:

The object of research is strength indicators of load-bearing structures of special rolling stock (dump cars). The research problem is the appearance of the same type of cracks in the girder beams of dump cars, the repair of which is not provided for by the current repair documentation. Malfunction analysis, control tests, strength studies by calculation and experiment were carried out. The analysis of malfunctions of cars in operation helped prove the place of occurrence of fatigue defects – the girder beam. This made it possible to determine specific zones of load-bearing elements, in which during control tests of cars, on the basis of taking into account data on fatigue defects, it is necessary to measure stress parameters. The results of the control tests showed that the lowest value of the fatigue resistance reserve factor n=1.6 for the dump car is found in the zone on the girder beam in the area of the pivot beam. The value of n is within acceptable limits. Normative calculations were carried out and a separate calculation (emergency) mode was additionally defined in the SolidWorks Simulation 2019 software package (France). Based on the results of the dump car stress calculations, it was established that the maximum equivalent stresses in the load-bearing structures of the car occur during its unloading due to twisting, and the stress vectors are at an angle of 45°. During the calculation of individual load modes, the stresses exceed the permissible values. In order to ensure the necessary strength conditions, it is proposed to introduce a reinforcing pad into the girder beam of the dump car, due to which the calculated stresses are within the permissible limits. The research will contribute to devising the recommendations for the restoration of dump cars, for designing modern structures of special rolling stock, and for improving strength determination processes Author Biographies Oleksii Koshel, State University of Infrastructure and Technologies Postgraduate Student Department of Railway Carriage and Railway Carriage Property

Anahtar Kelimeler:

Atıf Yapanlar
Bilgi: Bu yayına herhangi bir atıf yapılmamıştır.
Benzer Makaleler










Eastern-European Journal of Enterprise Technologies

Alan :   Fen Bilimleri ve Matematik

Dergi Türü :   Uluslararası

Metrikler
Makale : 4.764
Atıf : 4.485
2023 Impact/Etki : 0.294
Eastern-European Journal of Enterprise Technologies