Bu çalışmada, farklı nozul geometrileri ile aşındırıcı püskürtülmesi sonucu polimetil metakrilat (PMMA) malzemede ortaya çıkan erozif aşınma davranışları karakterize edilmiştir. Erozif aşınmada aşındırıcı partikül hızını ve hedef malzemede ortaya çıkan hasar mekanizmasını etkileyen en önemli faktörlerden bir tanesi nozul içi geometrisidir. Endüstride farklı nozul geometrileri, mikro aşındırıcı jet ile işleme ve kumlama gibi birçok farklı uygulamada kullanılmaktadır. Aşındırıcı püskürtme; geleneksel aşındırıcıyla malzeme işleme yöntemlerinden bir tanesidir ve mikro aşındırıcı jet ile işleme, yüzey işleme, yüzey temizleme gibi birçok kullanım alanına sahiptir. Bu metotta amaç basınçlı taşıyıcı bir gaz kullanarak aşındırıcı partikülleri nozul içinden geçirerek hızlandırıp hedef malzeme yüzeyine çarptırmaktır. Maksimum aşınma oranı, giriş ve çıkış çapı 5 mm olan ve tam ortada 4 mm çaplı boğaza sahip nozulda ortaya çıkarken; minimum aşınma oranı giriş çapı 3 mm çıkış çapı 2 mm olan daralan nozul geometrisinde gözlemlenmiştir. Maksimum ve minimum etki alanı değerleri de; erozyon oranlarının elde edildiği nozullarda gözlemlenmiştir. Maksimum ortalama yüzey pürüzlülüğü 3 mm çaplı sabit kesitli nozulla püskürtme sonrası ortaya çıkarken, minimum ortalama pürüzlülük değeri giriş ve çıkış çapı 5 mm olan ve tam ortada 3 mm çaplı boğaza sahip nozulda ortaya çıkmıştır
This study characterized the erosive exhaust behaviors arising in the material of polymethyl metacrylate (PMMA) as a result of intermittent spraying with different nozzle geometries. One of the most important factors affecting the speed of the inducing particles and the mechanism of damage that occurs in the target material in the erosive extinction is the intramuscular geometry. In the industry, different nozzle geometries are used in many different applications, such as processing and rubbing with micro-switching jet. Spraying is one of the methods of material processing with the traditional spraying machine and has many uses such as micro-spraying jet processing, surface processing, surface cleaning. The purpose of this method is to accelerate the transmitting particles through the nitrogen by using a pressure-bearing gas and to hit the target material surface. The maximum stretching rate occurs in the nozzle with a diameter of 5 mm of entrance and exit and a diameter of 4 mm in the middle; the minimum stretching rate is observed in the narrow nozzle geometry with a diameter of 3 mm of exit and a diameter of 2 mm. The maximum and minimum impact field values are also observed in the nozzles where the rate of erosion is achieved. The maximum average surface smoothness occurs after spraying in a 3 mm diameter fixed cutting nozzle, while the minimum average smoothness value occurs in a nozzle with a 5 mm in- and out diameter and a 3 mm diameter throat in the middle.
Alan : Mimarlık, Planlama ve Tasarım; Mühendislik
Dergi Türü : Uluslararası
Benzer Makaleler | Yazar | # |
---|
Makale | Yazar | # |
---|