Kullanım Kılavuzu
Neden sadece 3 sonuç görüntüleyebiliyorum?
Sadece üye olan kurumların ağından bağlandığınız da tüm sonuçları görüntüleyebilirsiniz. Üye olmayan kurumlar için kurum yetkililerinin başvurması durumunda 1 aylık ücretsiz deneme sürümü açmaktayız.
Benim olmayan çok sonuç geliyor?
Birçok kaynakça da atıflar "Soyad, İ" olarak gösterildiği için özellikle Soyad ve isminin baş harfi aynı olan akademisyenlerin atıfları zaman zaman karışabilmektedir. Bu sorun tüm dünyadaki atıf dizinlerinin sıkça karşılaştığı bir sorundur.
Sadece ilgili makaleme yapılan atıfları nasıl görebilirim?
Makalenizin ismini arattıktan sonra detaylar kısmına bastığınız anda seçtiğiniz makaleye yapılan atıfları görebilirsiniz.
 Görüntüleme 12
 İndirme 1
A study of the effect of deposition conditions on the phase-structural state of ion-plasma WC – TiC coatings
2019
Dergi:  
Eastern-European Journal of Enterprise Technologies
Yazar:  
Özet:

Studies of the influence of thermal and radiation factors on the elemental composition and phase-structural state of WC-TiC ion-plasma condensates of a quasibinary system are presented. As a thermal factor, we used different substrate temperatures during deposition and temperatures of high-temperature annealing of coatings after their deposition. The influence of the radiation factor was changed by applying a negative bias potential of different magnitudes to the substrate during coating deposition. It was found that with a change in the substrate temperature during deposition (in the temperature range 80–950 °C), a change occurs in the elemental composition of the coating. With an increase in the deposition temperature, the relative content of heavy metal atoms W increases and the relative content of Ti and C atoms decreases. At the phase-structural level, this leads to a change from the single-phase state ((W, Ti)C supersaturated solid solution at a deposition temperature of less than 700 °C) to two-phase ((W, Ti)C and α-W2C phases at a deposition temperature of more than 700 °C). The use of high-temperature annealing of coatings after their formation showed a relatively low decay activation efficiency. At an annealing temperature of 800 °C, a noticeable change in the phase-structural state is not observed, and at the highest temperature of 1000 °C and holding for 2 hours, the content of the α-W2C phase is relatively small and does not exceed 15 vol %. The supply of a bias potential stimulates the formation of a two-phase state from (W, Ti)C and α-W2C phases with nanometer crystallite size. With an increase in the bias potential from –50 V to –115 V, the average crystallite size decreases from 4.5 nm to 3.8 nm.The use of structural engineering methods in the work to create two-phase materials based on a quasibinary WC-TiC system is the basis for increasing the strength and crack resistance of coatings of such systems Author Biographies Oleg Sоbоl`, National Technical University "Kharkiv Polytechnic Institute" Kyrpychova str., 2, Kharkiv, Ukraine, 61002 Doctor of Physical and Mathematical Sciences, Professor Department of Materials Science

Anahtar Kelimeler:

Atıf Yapanlar
Bilgi: Bu yayına herhangi bir atıf yapılmamıştır.
Benzer Makaleler












Eastern-European Journal of Enterprise Technologies

Alan :   Fen Bilimleri ve Matematik

Dergi Türü :   Uluslararası

Metrikler
Makale : 4.764
Atıf : 4.485
2023 Impact/Etki : 0.294
Eastern-European Journal of Enterprise Technologies