Kullanım Kılavuzu
Neden sadece 3 sonuç görüntüleyebiliyorum?
Sadece üye olan kurumların ağından bağlandığınız da tüm sonuçları görüntüleyebilirsiniz. Üye olmayan kurumlar için kurum yetkililerinin başvurması durumunda 1 aylık ücretsiz deneme sürümü açmaktayız.
Benim olmayan çok sonuç geliyor?
Birçok kaynakça da atıflar "Soyad, İ" olarak gösterildiği için özellikle Soyad ve isminin baş harfi aynı olan akademisyenlerin atıfları zaman zaman karışabilmektedir. Bu sorun tüm dünyadaki atıf dizinlerinin sıkça karşılaştığı bir sorundur.
Sadece ilgili makaleme yapılan atıfları nasıl görebilirim?
Makalenizin ismini arattıktan sonra detaylar kısmına bastığınız anda seçtiğiniz makaleye yapılan atıfları görebilirsiniz.
 Görüntüleme 37
 İndirme 3
Establishing the influence of the type of micro- and nanofillers on the thermophysical properties of highly heat conductive polymer composites based on polyamide 6
2022
Dergi:  
Eastern-European Journal of Enterprise Technologies
Yazar:  
Özet:

The object of this study is the thermophysical properties of polymer micro- and nanocomposites, as well as the dependence of their heat conductivity with structural characteristics when using different types of fillers. A set of experimental studies of heat conductivity and specific heat capacity of polymer micro- and nanocomposite materials for polyamide 6 and carbon nanotubes, copper and aluminum as matrix and fillers was carried out. When obtaining composites, a method was used that is based on the mixing of components in the polymer melt. The content of fillers varied from 0.3 to 10 %, and the temperature of composite materials – from 305 to 500 K. Experimental dependences of heat conductivity coefficients of the studied composites on the content of the filler were derived. It was established that according to the value of these coefficients in order of their reduction, these composite materials are ranked as follows: composites with fillers with carbon nanotubes, copper, and aluminum. It was found that only one percolation threshold is observed, when using a polyamide 6 matrix. The regularities of changes in the specific heat capacity of the composites under consideration on their temperature when varying within the above limits of the filler content were investigated. The analysis of the influence of the content of fillers on the degree of crystallinity of the polymer matrix of the investigated composite materials was carried out. It is shown that with an increase in the content of fillers, the degree of crystallinity decreases. The relationship between the thermally conductive properties of the composites under consideration and the specified degree of crystallinity has been established. Higher values of heat conductivity of composites correspond to lower values of the degree of crystallinity. The reported results can be widely used in the development of highly heat conductive composites for various engineering applications. Author Biographies Nataliia Fialko, Institute of Engineering Thermophysics of the National Academy of Sciences of Ukraine Doctor of Technical Sciences, Professor, Corresponding Member of the National Academy of Sciences of Ukraine Department of Thermophysics of Energy Efficient Heat Technologies

Anahtar Kelimeler:

2022
Yazar:  
Atıf Yapanlar
Bilgi: Bu yayına herhangi bir atıf yapılmamıştır.
Benzer Makaleler








Eastern-European Journal of Enterprise Technologies

Alan :   Fen Bilimleri ve Matematik

Dergi Türü :   Uluslararası

Metrikler
Makale : 4.764
Atıf : 4.485
2023 Impact/Etki : 0.294
Eastern-European Journal of Enterprise Technologies