Bu çalışmada tel elektrot erozyon ile işlemede makine performansını değerlendirmede en önemli parametrelerden biri olan işleme hızı üzerine farklı tel elektrotların, soğutma yöntemlerinin ve iş parçalarının etkileri araştırılmıştır. Deneysel çalışmalarda, iş parçası malzemesi olarak AISI D2 takım çeliği ve AISI 304 paslanmaz çelik, tel elektrot olarak ise pirinç, bakır ve çinko kaplı pirinç tel elektrotlar ve soğutma tipi olarak püskürtmeli ve daldırılmış soğutma yöntemleri kullanılmıştır. İşleme hızı değerleri sonuçları farklı işleme parametrelerine bağlı olarak değerlendirilmiştir. Genel olarak elektrot tipine göre en yüksek kesme hızları bakır tel elektrot ile en düşük işleme hızları ise kaplamasız pirinç tel elektrot ile elde edilmiştir. Daldırılmış soğutma yöntemi En yüksek kesme hızları elde etmek açısından püskürtmeli yöntemden daha iyi sonuçlar vermiştir. Genellikle iş parçasına bağlı olarak en yüksek işleme hızları AISI D2 takım çeliği malzemesi işlenirken, en düşük işleme hızları ise AISI 304 östenitik paslanmaz çeliği işlenirken oluşmuştur.
This study examined the effects of different wire electrots, cooling methods and work parts on the processing speed, which is one of the most important parameters in the assessment of the machine performance in the processing with wire electrots erotion. In experimental studies, AISI D2 equipment steel and AISI 304 stainless steel were used as a piece of work material, and as a wire electrots, rice wire electrots covered with copper and zinc and the cooling type were sprinkled and immersed cooling methods. Processing speed values are assessed according to different processing parameters. In general, the highest cutting speeds according to the type of electrots are made by the copper wire electrots and the lowest processing speeds are made by the uncovered rice wire electrots. The lifted cooling method has given better results than the spray method in terms of obtaining the highest cutting rates. Usually depending on the work piece, the highest processing speeds are the AISI D2 steel material processing, while the lowest processing speeds are the AISI 304 esthetic stainless steel processing.
Alan : Mühendislik
Dergi Türü : Ulusal
Benzer Makaleler | Yazar | # |
---|
Makale | Yazar | # |
---|