Citation Number
1
Views
9
Downloands
3
Bu çalışmada Ti-27Ni-20Nb-3V (% at.) alaşımı ark-ergitme yöntemi ile üretildi. Üretilen alaşım 850 ℃ de 24 saat homojenleştirildikten sonra, faz dönüşüm sıcaklıkları, mikro-yapısı, elektrokimyasal aşınma direnci, mikrosertlik gibi fiziksel ve kimyasal özellikleri araştırıldı. DSC yardımıyla faz dönüşüm sıcaklıkları austenite-martensite faz geçişlerinin oda sıcaklığının altında olduğu belirlendi. Optik mikroskop (OM) ve SEM görüntülerinde alaşımın dentrik yapıdan oluştuğu, XRD patterninde -Nb, B2 ve B19/ piklerine rastlandı. Ayrıca, yapılan hesaplamalar sonucu kristalit tane boyutu yaklaşık 39,65 nm olarak hesaplandı. Oda sıcaklığında SBF’de (yapay vücut sıvısı) yapılan elektrokimyasal analizi sonucu korozyon direnci 8,09x10-5 mmpy olarak hesaplandı. Mikrosertlik ölçümlerinde alaşımın mikrosertliği beş ayrı bölgeden alınarak ortalama 810 HV olarak bulundu.
In this study, Ti-27Ni-20Nb-3V (% at.) The alloy was produced by the arc-erge method. After the produced alloy was homogenized at 850 °C for 24 hours, physical and chemical characteristics such as phase conversion temperatures, micro-building, electrochemical stretching resistance, microsurgency were studied. With the help of DSC, phase conversion temperatures were determined that austenite-martensite phase transitions were below room temperature. In the optical microscope (OM) and SEM images, the alloy is made up of a dentric structure, the XRD pattern found the
In this study Ti-27Ni-20Nb-3V (% at.) alloy was produced by arc- melting method. After the produced alloy was homogenized at 850 ℃ for 24 hours, its pysical and chemical properties such as phase transformation temperatures, micro-structure, electro chemical wear resistance, microhardness were investigated. Phase transformation temperatures were determined with the help of DSC that autenite-martensite phase transitions were below room temperature. In optical microscope (OM) and SEM images, -Nb, B2 ve B19/ were found in XRD pattern, where the alloy is composed of dendritic structure. In addition, as a result of the calculations, the crystallite particle size was calculated as approximately 39,65 nm. Corrosion resistance was calculated as 8,09x10-5 mmpy as a result of electrochemical analysis performed in SBF (artificial body fluid) at room temperature. In microhardness measurements, the microhardness of the alloys was taken from five different regions and found to be 810 HV on average.
Field : Fen Bilimleri ve Matematik; Mühendislik
Journal Type : Ulusal
Article Detail 
Citation Owners
Similar Articles
Download PDF
Journal Information
Listen Paper
Print This Page
Share
Mendeley
