Kullanım Kılavuzu
Neden sadece 3 sonuç görüntüleyebiliyorum?
Sadece üye olan kurumların ağından bağlandığınız da tüm sonuçları görüntüleyebilirsiniz. Üye olmayan kurumlar için kurum yetkililerinin başvurması durumunda 1 aylık ücretsiz deneme sürümü açmaktayız.
Benim olmayan çok sonuç geliyor?
Birçok kaynakça da atıflar "Soyad, İ" olarak gösterildiği için özellikle Soyad ve isminin baş harfi aynı olan akademisyenlerin atıfları zaman zaman karışabilmektedir. Bu sorun tüm dünyadaki atıf dizinlerinin sıkça karşılaştığı bir sorundur.
Sadece ilgili makaleme yapılan atıfları nasıl görebilirim?
Makalenizin ismini arattıktan sonra detaylar kısmına bastığınız anda seçtiğiniz makaleye yapılan atıfları görebilirsiniz.
  Atıf Sayısı 8
 Görüntüleme 24
Establishing patterns in determining the dynamics and strength of a covered freight car, which exhausted its resource
2020
Dergi:  
Eastern-European Journal of Enterprise Technologies
Yazar:  
Özet:

This paper substantiates prolonging the service life of a covered railroad freight car that has exhausted its rated life of operation. In this case, the actual amount of wear of the bearing structure elements, registered during operation, have been taken into consideration. The reported calculations showed that the design service life of the bearing structure of a covered freight car when taking into consideration the extension of operation, is not less than 2 years. Mathematical modeling was carried out to determine the dynamic load on the bearing structure of a covered freight car. It has been established that the maximum accelerations that act on the bearing structure of a covered freight car are 42 m/s2. In order to determine the acceleration distribution fields relative to the bearing structure of a covered freight car, a computer simulation was performed. The calculations showed that the maximum acceleration amounts to 43.2 m/s2 and is concentrated in the middle part of the girder beam. F-criterion was used to verify the dynamic load models. The maximum equivalent stresses of the bearing structure of a covered freight car were determined taking into consideration the wear of its components. It was found that the maximum equivalent stresses occur in the area of interaction between the girder beam and the rod beam and amount to 344 MPa. In other words, the maximum equivalent stresses do not exceed permissible ones. The basic dynamic indicators for a covered freight car have been calculated. The maximum accelerations that act on the bearing structure of a covered freight car in the center of masses reached about 5 m/s2. The acceleration of the body in the regions of resting on bogies was about 6 m/s2. The travel of the car is rated «good».This study would contribute to improving the efficiency of the transportation process, as well as the functioning of railroad transport Author Biographies Oleksij Fomin, State University of Infrastructure and Technologies Kyrylivska str., 9, Kyiv, Ukraine, 04071 Doctor of Technical Sciences, Professor Department of Cars and Carriage Facilities

Anahtar Kelimeler:

Atıf Yapanlar
Dikkat!
Yayınların atıflarını görmek için Sobiad'a Üye Bir Üniversite Ağından erişim sağlamalısınız. Kurumuzun Sobiad'a üye olması için Kütüphane ve Dokümantasyon Daire Başkanlığı ile iletişim kurabilirsiniz.
Kampüs Dışı Erişim
Eğer Sobiad Abonesi bir kuruma bağlıysanız kurum dışı erişim için Giriş Yap Panelini kullanabilirsiniz. Kurumsal E-Mail adresiniz ile kolayca üye olup giriş yapabilirsiniz.
Benzer Makaleler












Eastern-European Journal of Enterprise Technologies

Alan :   Fen Bilimleri ve Matematik

Dergi Türü :   Uluslararası

Metrikler
Makale : 4.764
Atıf : 4.485
2023 Impact/Etki : 0.294
Eastern-European Journal of Enterprise Technologies